Drew Technologies DashDAQ Series II Manuel d'instructions télécharger pdf (Page 51)

APPENDIX A: ACCESSORY CABLE PIN OUT

Red Vehicle Power In/Out

If DashDAQ is connected via

OBD2 cable, this is the source

for vehicle power. If OBD2 is not

connected, vehicle power must

be applied here. Warning! Do

not attempt to power any

device from this output that

draws more that 500ma of

current. Failure to observe this

restriction could result in

permanent un-repairable

damage to your DashDAQ.

Orange Serial Port 1 Rx Connect to pin 3 of PC DB-9

Yellow Serial Port 2 Tx Connect to pin 2 of PC DB-9

Blue Serial Port 2 Rx Connect to pin 3 of PC DB-9

Brown Serial Port 1 Tx Connect to pin 2 of PC DB-9

Black Case Ground 1Meg Ohm to Gnd. For cable

shielding. Do not use as a

Ground.

White Analog input 2 0.0 to 5.0 Volt input

Pink 5V @ 500ma Output Resettable fuse protected.

Green Analog input 1 0.0 to 5.0 Volt input

Shield Ground This is the signal ground.

Connect to pin 5 of PC DB-9

Note: For future compatibility tie 6 and 10 together.

1 2 ... 46 47 48 49 50 51 52

Pas de commentaire

Drew Technologies DashDAQ Series II Manuel d'instructions Page 51