Drew Technologies DashDAQ Series II Manuel d'instructions télécharger pdf (Page 11)

3 Gauge Setup & Navigation

This section describes how to setup gauges and

navigate.

3.1

Navigating Gauges:

To access DashDAQ gauges, tap on [Gauges] from

the Main Menu. The last gauge layout you selected

or this screen will be displayed.

To change gauge layouts, tap on the [<<] and [>>]

buttons. Here are a few examples:

Every gauge and box can be assigned a

parameter/signal.

3.2

Assign a Signal to a Gauge

Before specifying what signal you would like a

gauge to display, make sure the New Vehicle

procedure has been completed.

1. To assign a signal to a gauge, select a

gauge screen. Tap on the gauge where you

would like a signal to display. This screen

will appear:

2. Tap on [Assign Signal]. Notice the [<] and [>]

buttons at the top of the screen.

These allow to switch which DashDAQ input you

would like to use (Optional Accessories). OBDII is

the default. Pick which signal you would like to

monitor and tap [Save].

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

Pas de commentaire

Drew Technologies DashDAQ Series II Manuel d'instructions Page 11