Drew-technologies CarDAQ-Plus Manuel d'utilisateur télécharger pdf (Page 5)

3. The CarDAQ-Plus drivers and the J2534 ToolBox will now begin

installation. Follow the Setup Wizard instructions.

4. When the installation is finished, power up your CarDAQ-Plus

from a vehicle with the OBDII cable, and then connect the USB

cable from CarDAQ-Plus to your PC. The drivers will

automatically be found and installed on Windows Vista and 7

computers.

For Windows XP, a few more steps are required:

a. The “Found New Hardware Wizard” will pop up when you

connect your CarDAQ-Plus.

b. Make sure “No, not this time” is selected and click [Next].

This screen appears:

c. Select “Install the software automatically

(Recommended)” and click [Next]. After the progress bar

finishes, click [Finish]. Windows XP users are finished

installing at this point and can run the software they will

be using with the CarDAQ-Plus.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Drew-technologies CarDAQ-Plus Manuel d'utilisateur Page 5